The process
A waste heat boiler sits on the exhaust of a kiln, furnace or engine and lowers the gas temperature before the dust collector and fan. The ID fan after the boiler handles the gas of the source process at reduced temperature, and dampers divert the gas around the boiler when it is out of service.
The gas
Exhaust from a kiln, furnace or engine after a waste heat boiler. Temperature and dust depend on the upstream process; the fan is selected at the hot condition with the dust load of the source.
Selection for this process
| Type | Guillotine for isolation, multi louver or butterfly for control, diverter where the gas is switched between two paths |
| Material | Mild steel |
| Sealing | Seal air arrangement where tight shut-off is needed on hot or dusty gas |
Types, construction and performance of the dampers.
Industries
Fans in waste heat recovery boilers
Dampers in other processes
Cement Preheater KilnsVertical Roller Raw MillsClinker Grate CoolersRotary Lime KilnsSponge Iron Rotary KilnsBlast Furnace Hot Blast StovesSinter PlantsElectric Arc Furnace SteelmakingLadle Furnaces and Secondary MetallurgySteel Reheating FurnacesFerro Alloy Submerged Arc FurnacesCopper and Zinc SmeltingGlass Melting FurnacesCeramic Tunnel and Roller KilnsWaste IncineratorsRefinery Fired HeatersNuclear Facility VentilationBOF Steel ConvertersIron Ore Pellet Plants
Information needed to select or quote
- Gas volume and temperature. Actual flow at the inlet, normal and upset temperature, moisture.
- Dust or pollutant. Inlet loading, particle size distribution, whether it is abrasive, sticky, hygroscopic or combustible; for gases, the species and concentration.
- Required outlet. The emission limit or clean gas concentration the unit must meet.
- Site. Available space and height, material of construction preferences, and how the collected material is to be discharged.