The process
Small two-chamber incinerators for hospital waste use a venturi or packed bed scrubber and an ID fan in stainless steel or FRP. Volumes are small and the duty is intermittent, so the fan is built for corrosion rather than for size.
The gas at the fan
Flue gas after the quench and scrubber is wet, acidic and still carries fine dust. The fan is in stainless steel or lined construction, with a shaft seal and drains, sized at the saturated density.
Selection for this duty
| Construction | Stainless steel or lined vessel with mesh pad or vane pack sized for the droplet load |
| Density at the fan | At about 200°C the gas density is close to 0.75 kg/m³, 62% of standard air. Pressure developed and power drawn fall in the same ratio, so the selection is made at this density and the motor is checked at cold start. |
Separates entrained liquid droplets from a vapour or gas stream, ahead of a compressor, a fan or a stack. Client-stated blade types for the Mist Eliminator in general: Demister Knockdown Vessel.
Industries
Other fans in biomedical waste incinerators
Mist Eliminator in other processes
Hot Dip Galvanising LinesWaste IncineratorsChemical Reactor and Tank VentsMVR EvaporatorsEffluent Treatment and Zero Liquid Discharge PlantsFertilizer Granulation PlantsSulphuric Acid PlantsFlare and Pressure Relief SystemsGas Compressor StationsPaper Machine Dryer SectionsTextile Stenters and DryersPickling and Acid Treatment LinesCold Rolling MillsBOF Steel ConvertersEdible Oil Solvent Extraction Plants
Information needed to select or quote
- Gas volume and temperature. Actual flow at the inlet, normal and upset temperature, moisture.
- Dust or pollutant. Inlet loading, particle size distribution, whether it is abrasive, sticky, hygroscopic or combustible; for gases, the species and concentration.
- Required outlet. The emission limit or clean gas concentration the unit must meet.
- Site. Available space and height, material of construction preferences, and how the collected material is to be discharged.