The process
The sinter strand draws air down through the burning bed with a large ID fan, the main exhauster, handling waste gas that is hot, dusty and acidic. Dedusting fans serve the cooler and the material handling, all on abrasive ore and flux fines.
The gas at the fan
Sinter strand waste gas carries ore and flux fines with acid components from the sulphur in the fuel. Wear and corrosion both act on the wheel; material and liner selection follow the gas analysis.
Selection for this duty
| Construction | Absorptive annular design in mild steel; stainless steel where the gas is wet or corrosive |
| Density at the fan | At about 150°C the gas density is close to 0.83 kg/m³, 69% of standard air. Pressure developed and power drawn fall in the same ratio, so the selection is made at this density and the motor is checked at cold start. |
An absorptive silencer at the fan inlet, outlet or in the duct, cutting fan noise with minimum pressure loss. Client-stated blade types for the Fan Silencer in general: Silencer.
Industries
Other fans in sinter plants
Fan Silencer in other processes
Bagasse Fired BoilersRice Husk Fired BoilersAFBC BoilersCFBC BoilersPulverised Coal Fired BoilersOil and Gas Fired BoilersWaste Heat Recovery BoilersBiomass Fired BoilersThermic Fluid HeatersBlast Furnace Hot Blast StovesSteel Reheating FurnacesPharmaceutical Clean RoomsRefinery Fired HeatersFlare and Pressure Relief SystemsGas Compressor StationsCaptive Power PlantsGenerator and Engine RoomsCar Parks and TunnelsNuclear Facility VentilationHospitals and LaboratoriesData Centres and Equipment RoomsDistillery Spent Wash Incineration Boilers
Information needed to select or quote
- Gas volume and temperature. Actual flow at the inlet, normal and upset temperature, moisture.
- Dust or pollutant. Inlet loading, particle size distribution, whether it is abrasive, sticky, hygroscopic or combustible; for gases, the species and concentration.
- Required outlet. The emission limit or clean gas concentration the unit must meet.
- Site. Available space and height, material of construction preferences, and how the collected material is to be discharged.