The process
Operating theatres, isolation rooms and laboratories need AHUs with HEPA filtration, pressure control between rooms and fume cupboard extraction in corrosion resistant construction.
The gas at the fan
Filtered, conditioned supply air through pre, fine and HEPA filters. The fan is selected against the filter pressure drop as it loads, at low noise.
Selection for this duty
| Construction | Absorptive annular design in mild steel; stainless steel where the gas is wet or corrosive |
| Density at the fan | At about 22°C the gas density is close to 1.20 kg/m³, 99% of standard air. Pressure developed and power drawn fall in the same ratio, so the selection is made at this density and the motor is checked at cold start. |
An absorptive silencer at the fan inlet, outlet or in the duct, cutting fan noise with minimum pressure loss. Client-stated blade types for the Fan Silencer in general: Silencer.
Industries
Other fans in hospitals and laboratories
Fan Silencer in other processes
Bagasse Fired BoilersRice Husk Fired BoilersAFBC BoilersCFBC BoilersPulverised Coal Fired BoilersOil and Gas Fired BoilersWaste Heat Recovery BoilersBiomass Fired BoilersThermic Fluid HeatersBlast Furnace Hot Blast StovesSinter PlantsSteel Reheating FurnacesPharmaceutical Clean RoomsRefinery Fired HeatersFlare and Pressure Relief SystemsGas Compressor StationsCaptive Power PlantsGenerator and Engine RoomsCar Parks and TunnelsNuclear Facility VentilationData Centres and Equipment RoomsDistillery Spent Wash Incineration Boilers
Information needed to select or quote
- Gas volume and temperature. Actual flow at the inlet, normal and upset temperature, moisture.
- Dust or pollutant. Inlet loading, particle size distribution, whether it is abrasive, sticky, hygroscopic or combustible; for gases, the species and concentration.
- Required outlet. The emission limit or clean gas concentration the unit must meet.
- Site. Available space and height, material of construction preferences, and how the collected material is to be discharged.