The process
The sinter strand draws air down through the burning bed with a large ID fan, the main exhauster, handling waste gas that is hot, dusty and acidic. Dedusting fans serve the cooler and the material handling, all on abrasive ore and flux fines.
The gas at the fan
Sinter strand waste gas carries ore and flux fines with acid components from the sulphur in the fuel. Wear and corrosion both act on the wheel; material and liner selection follow the gas analysis.
Selection for this duty
| Blade form | Radial tipped with wear liners, or straight radial where the dust is coarse |
| Material of construction | Stainless steel on all wetted parts, grade to suit the gas analysis |
| Drive and bearings | Direct coupled or belt driven with a shaft cooling disc and bearings outside the casing |
| Also specified | Hard facing or liners on the blade pressure face |
| Density at the fan | At about 150°C the gas density is close to 0.83 kg/m³, 69% of standard air. Pressure developed and power drawn fall in the same ratio, so the selection is made at this density and the motor is checked at cold start. |
The fan behind a bag filter, cyclone or multiclone on a dust extraction system. Placed on the clean side where possible so the blade can be chosen for efficiency. Client-stated blade types for the Dust Collector Fan in general: Backward inclined and radial tipped.
Industries
Other fans in sinter plants
Dust Collector Fan in other processes
Bagasse Fired BoilersRice Husk Fired BoilersAFBC BoilersCFBC BoilersPulverised Coal Fired BoilersWaste Heat Recovery BoilersBiomass Fired BoilersThermic Fluid HeatersCement Preheater KilnsVertical Roller Raw MillsBall Mill Raw GrindingCement Grinding MillsClinker Grate CoolersCement Plant Coal MillsCement Packing and DispatchRotary Lime KilnsVertical Shaft Lime KilnsGypsum Calcining PlantsSponge Iron Rotary KilnsBlast Furnace Hot Blast StovesCoke Oven BatteriesElectric Arc Furnace SteelmakingInduction Furnace Melt ShopsLadle Furnaces and Secondary Metallurgy
Services on this fan
Information needed to select or quote
- Duty point. Volume flow and static pressure at the fan inlet, with the gas density and temperature or the conditions to derive it.
- Operating conditions. Site altitude, normal operating temperature and continuous or intermittent duty.
- Gas stream. Dust loading and particle size, corrosive species, moisture, upset temperature and any tendency of the material to deposit on the impeller.
- Mechanical. Rotation viewed from the drive end, discharge orientation and motor power.