The process
A paint shop is an air system: conditioned supply through AHUs to the booths, exhaust with overspray through water wash or dry filters, solvent abatement by adsorption or oxidation, and ovens with recirculation fans. Spark resistant construction on the exhaust side.
The gas at the fan
Booth exhaust carries paint overspray that cures on anything it lands on, with solvent vapour. Spark resistant, a blade form that is easy to clean, and the fan after the booth filters or scrubber.
Selection for this duty
| Blade form | Backward inclined or backward curved; the residual dust does not justify a radial wheel |
| Material of construction | Mild steel |
| Drive and bearings | Direct coupled or belt driven; belt drive where the duty point may need tuning at site |
| Also specified | Spark resistant construction with non-ferrous rubbing parts, shaft seal, earthing and a flameproof or increased safety motor; access doors on the scroll and a wheel that can be cleaned in place |
| Density at the fan | At about 35°C the gas density is close to 1.15 kg/m³, 95% of standard air. Pressure developed and power drawn fall in the same ratio, so the selection is made at this density and the motor is checked at cold start. |
Moves air through a plant or building for fresh air supply, heat removal and fume dilution where the system is ducted. Low pressure, long hours, so efficiency and noise set the selection. Client-stated blade types for the Ventilation Fan in general: Backward inclined and forward curved.
Industries
Other fans in automotive paint shops
Ventilation Fan in other processes
Bagasse Fired BoilersRice Husk Fired BoilersAFBC BoilersCFBC BoilersPulverised Coal Fired BoilersOil and Gas Fired BoilersBiomass Fired BoilersCement Packing and DispatchElectric Arc Furnace SteelmakingInduction Furnace Melt ShopsHeat Treatment FurnacesForge ShopsAluminium Smelters and Cast HousesIron and Non-ferrous FoundriesGlass Forming and Annealing LehrsBrick and Refractory KilnsChemical Reactor and Tank VentsMVR EvaporatorsEffluent Treatment and Zero Liquid Discharge PlantsPharmaceutical Clean RoomsSolvent Recovery PlantsGas Compressor StationsBelt and Tray DryersTea Withering Troughs
Services on this fan
Information needed to select or quote
- Duty point. Volume flow and static pressure at the fan inlet, with the gas density and temperature or the conditions to derive it.
- Operating conditions. Site altitude, normal operating temperature and continuous or intermittent duty.
- Gas stream. Dust loading and particle size, corrosive species, moisture, upset temperature and any tendency of the material to deposit on the impeller.
- Mechanical. Rotation viewed from the drive end, discharge orientation and motor power.