The process
The rotary dryer takes hot air from a furnace and the cooler takes ambient air, both through the product bed with exhaust fans that pull the dust-laden air through cyclones and scrubbers.
The gas at the fan
Dryer exhaust with heavy carry-over of the dried material and the moisture it gave up. Dust goes to a cyclone and bag filter, and the fan behind them handles warm, wet gas with residual fines.
Selection for this duty
| Blade form | Radial tipped with wear liners, or straight radial where the dust is coarse |
| Material of construction | Mild steel with replaceable wear liners on the blades and the scroll at the cut-off, with a casing drain for the moisture |
| Drive and bearings | Direct coupled or belt driven; belt drive where the duty point may need tuning at site |
| Also specified | Hard facing or liners on the blade pressure face; casing drain at the lowest point |
| Density at the fan | At about 120°C the gas density is close to 0.90 kg/m³, 75% of standard air. Pressure developed and power drawn fall in the same ratio, so the selection is made at this density and the motor is checked at cold start. |
Sits at the outlet of a boiler, kiln or furnace and draws the flue gas through the plant to the stack. It handles hot, dust-laden gas at large volume, so it is sized at the hot condition and checked at cold start. Client-stated blade types for the ID Fan in general: Backward curved, backward inclined and radial tipped.
Industries
Other fans in fertilizer rotary dryers and coolers
Hot Air FanDust Collector FanBag Filter FanCombustion Air BlowerHigh Pressure BlowerCyclonic Separator
ID Fan in other processes
Bagasse Fired BoilersRice Husk Fired BoilersAFBC BoilersCFBC BoilersPulverised Coal Fired BoilersOil and Gas Fired BoilersWaste Heat Recovery BoilersBiomass Fired BoilersThermic Fluid HeatersHot Air GeneratorsRotary Lime KilnsVertical Shaft Lime KilnsGypsum Calcining PlantsSponge Iron Rotary KilnsBlast Furnace Hot Blast StovesSinter PlantsCoke Oven BatteriesElectric Arc Furnace SteelmakingSteel Reheating FurnacesHeat Treatment FurnacesFerro Alloy Submerged Arc FurnacesCopper and Zinc SmeltingGlass Melting FurnacesCeramic Tunnel and Roller Kilns
Services on this fan
Fan and System Performance TestingFan Energy AuditRetrofit of Low Efficiency FansRotor Replacement and Performance EnhancementDynamic Balancing and Vibration AnalysisCondition Monitoring and TroubleshootingInstallation, Commissioning and After-sales Support
Information needed to select or quote
- Duty point. Volume flow and static pressure at the fan inlet, with the gas density and temperature or the conditions to derive it.
- Operating conditions. Site altitude, normal operating temperature and continuous or intermittent duty.
- Gas stream. Dust loading and particle size, corrosive species, moisture, upset temperature and any tendency of the material to deposit on the impeller.
- Mechanical. Rotation viewed from the drive end, discharge orientation and motor power.